Harbor Freight Tools Planer 94840 User Manual

RADIO CONTROLLED  
BIPLANE  
94840  
ASSEMBLY & OPERATING INSTRUCTIONS  
Important: If damage is caused due to a crash; your warranty is void.  
Due to continuing improvement, actual product may differ slightly from product described herein.  
®
3491 Mission Oaks Blvd., Camarillo, CA 93011  
Copyright© 2006 by Harbor Freight Tools®. All rights reserved. No portion of this manual or  
any artwork contained herein may be reproduced in any shape or form without the  
express written consent of Harbor Freight Tools.  
For technical questions and replacement parts please call 1-800-444-3353.  
 
7. Store idle equipment. When not in use always lock up the Biplane and keep it out of the  
reach of children.  
8. Dress properly. Wear restrictive hair covering to contain long hair.  
9. Use eye protection. Always wear ANSI-approved impact safety goggles when using and  
assembling this product.  
10. Maintain products with care. Keep the Biplane in a dry location. Do not expose it to  
prolonged moisture.  
11. Use the right Biplane for the job. Do not attempt to force a small Biplane to do the work of a  
larger Biplane. There are certain applications for which this Biplane was designed. Do not  
modify this Biplane and do not use this Biplane for a purpose for which it was not intended.  
12. Do not use or assemble the Biplane if under the influence of alcohol or drugs. Read  
warning labels on prescriptions to determine if your judgement or reflexes are impaired while  
taking drugs. If there is any doubt, do not assemble or use the Biplane.  
13. Do not pick up the Biplane while it is in motion.  
14. Use only batteries of the type recommended.  
15. Do not mix old and new batteries and remove batteries if the Biplane is not used for a  
long period of time.  
16. NiCad batteries must be disposed of properly. Do not incinerate. Batteries may burst,  
causing personal injury and/or property damage. Contact your local hazardous waste disposal  
authority for proper disposal.  
17. Do not recharge non-rechargeable batteries.  
18. Make certain to use the Biplane in a large area free from interference from trees,  
electrical power lines and other obstacles.  
19. Never fly near buildings, cars, busy streets or at other people or animals.  
20. Do not fly the Biplane if wind speeds are above 10 MPH.  
21. Do not allow children to use glue without adult supervision. Make certain that all glue  
is stored out of reach of children and animals.  
22. If two airplanes with the same frequency are used (both with the same numbers on the  
transmitter and/or receiver) they must be at least 1,640 feet away from one another.  
23. Before flying, perform a distance check to be certain that you can maintain radio control  
at least 25 feet from the transmitter to the Biplane with the antenna collapsed.  
24. Do not trim the Biplane’s antenna. Trimming the antenna will affect radio range.  
Warning: People with pacemakers should consult their physician(s) before using this  
product. Electromagnetic fields in close proximity to a heart pacemaker could cause  
interference to/or failure of the pacemaker.  
SKU 98480  
For technical questions please call 1-800-444-3353.  
Page 3  
 
WARNING: The warnings, cautions, and instructions discussed in this instruction manual cannot  
cover all possible conditions and situations that may occur. It must be understood by  
the operator that common sense and caution are factors which cannot be built into  
this product, but must be supplied by the operator.  
Assembly  
Your Biplane will require some assembly. It is important that you read the entire manual to become  
familiar with the product BEFORE you assemble and use the Biplane. Be sure that you have all  
parts described in the Parts List located on page 7 of this manual.  
Attaching the Battery Pack  
1.  
2.  
3.  
Turn off the power before connecting the Battery Pack to the Biplane.  
Plug the Battery Pack (4) into the outlet located on the Biplane as seen in Figure 1.  
Please note: The Battery Pack is installed from the rear by sliding it forward until it rests  
against the lip/stop on the airframe, as seen in Figure 2. Once installed, the Battery Pack  
should be locked into place by inserting the the rubber pin through the holes in the battery  
tray and airframe.  
Figure 2  
Figure 1  
Brackets for  
Battery Pack (4)  
Plug in  
Battery Pack  
here  
Charging the Battery Pack  
1.  
The Battery Pack (4) is charged from the Transmitter/Charger Unit (2). Plug the Battery  
Pack (4) into the Charging jack, located at the side of the Transmitter/Charger Unit (2)-see  
Figure 3.  
2.  
3.  
4.  
5.  
Hold down the red button until the battery indicator turns orange.  
A charge time of three to five minutes is usually sufficient.  
During charging the Battery Pack will get warm. Make certain it does not get overly hot.  
The Battery Pack must have three to four initial charges of a longer duration before they  
obtain a full run time of 4 to 6 minutes.  
SKU 98480  
For technical questions please call 1-800-444-3353.  
Page 4  
 
Figure 4  
LED readout  
Turn Control  
Stick  
On/Off  
Switch  
Figure 3  
Charging  
Jack  
Battery Pack (4)  
Transmitter/Charger Unit (2)  
Climb  
Control  
Stick  
Operating the Radio Transmitter  
1.  
The Transmitter uses 8 “AA” batteries (not included). Remove the Battery Compartment  
Cover (12)-see Figure 4. Insert the batteries into the Battery Compartment making certain to  
line up the batteries with the polarity indicated in the Battery Compartment. Press the  
Battery Compartment Cover (12) back into place.  
2.  
3.  
The Radio Transmitter (2) transmits a signal to the airplane’s receiver.  
The Radio Transmitter (2) has a LED display that will light up when the Transmitter is on.  
The LED readout will indicate the strength of the battery charge:  
Green indicates the batteries are at full capacity  
Yellow indicates the batteries are at half capacity  
Red indicates the batteries need replacing.  
4.  
5.  
The Radio Transmitter/Charger is turned ON and OFF with the On/Off Switch located  
midway between the Control Sticks-see Figure 4.  
The Radio Transmitter/Charger has two Control Sticks.  
The Control Stick located on the left moves vertically and controls the Climb. Push  
the Climb Control Stick forward to turn on the twin motors and cause the Biplane to climb.  
Pull back on the Climb Control Stick to slow down the twin motors and cause the Biplane to  
lower altitude-see Figure 4.  
The Control Stick located on the right moves horizontally and controls the direction of the  
Biplane. Pushing the Turn Control Stick right or left causes the Biplane to turn right or left.  
6.  
Attach the Wind Ribbon to the Radio Transmitter Antenna.  
Installing Propellers  
1.  
2.  
Make certain Radio Transmitter is OFF and that the Battery Pack is unplugged.  
The Biplane comes with spare Propellers. If necessary, remove the Nut holding each  
Propeller in place. Remove the Propeller. Install new Propeller.  
SKU 98480  
For technical questions please call 1-800-444-3353.  
Page 5  
 
Operating and Flying the Biplane  
Preparing for Take-Off  
1.  
Choose a day when the wind is light. The ribbon attached to the Radio Transmitter  
antenna should be blowing slightly (not greater than 30 degrees) and not be  
blowing straight out. Find a wide-open field.  
2.  
3.  
Turn ON the Radio Transmitter.  
Face the Biplane into the wind. Move the left hand control stick all the way forward so  
both motors are running at full power.  
Note: It is recommended that two people work together to hand launch the Biplane. One  
should control the Remote Control and one will launch the Biplane.  
4.  
5.  
With the Biplane tilted at about 10 degrees, propel and release it into the wind.  
Let the Biplane climb to and fly at about 50 to 300 feet high. By moving the Climb and Turn  
control sticks you can change speed and direction.  
6.  
To steer the Biplane, move the right Turn control stick to the left to steer to the left, and  
right to steer it right. Move the Turn Control Stick slightly to adjust for minor changes in  
direction and tilt of the Biplane.  
7.  
8.  
Note that letting go of the control sticks will automatically bring them to a center position.  
This will cause the Biplane to resume normal flight.  
Normal flight time for one full charge is about four to six minutes. When the battery begins  
to reach the end of its power, the red LED light on the Radio Transmitter will light up,  
indicating low transmitter power. When this occurs, IMMEDIATELY LAND THE BIPLANE.  
9.  
To bring in the Biplane for landing, glide the Biplane down against the wind. Move the  
left Climb control stick toward the center to slow the Propellers. Move the right Turn control  
stick to adust for direction. Continue to decrease the Propeller speed and direction until you  
bring them to a stop and land the Biplane.  
10.  
Turn OFF the Radio Transmitter.  
Important: If damage is caused due to a crash; your warranty is void.  
Inspection, Maintenance and Cleaning  
1.  
2.  
All inspections, maintenance, and cleaning should be performed only by an adult.  
Always make certain the Biplane is unplugged and that the Transmitter is OFF before  
performing any inspection, adjustments, maintenance or cleaning.  
3.  
Never use solvents or liquid cleaners to clean the Biplane. Use of solvents or liquid cleaners  
will damage the styrofoam. Use only a dry, soft cloth for cleaning.  
SKU 98480  
For technical questions please call 1-800-444-3353.  
Page 6  
 
4.  
Before each use check for loose screws, misalignment or binding of moving parts, cracked  
or broken parts, damaged housing, damaged wiring, loose wheels and any other condition  
that may affect its safe operation. If abnormal noise or vibration occurs, have the problem  
corrected before further use. Do not use the Biplane if it is damaged.  
5.  
Do not leave the Biplane outside as prolonged exposure to the elements will damage the  
exterior of the Biplane.  
Parts List  
Part #  
Description  
Quantity  
Part #  
Description  
Quantity  
1
2
Biplane Body  
Radio Transmitter/  
Charger Unit  
Antenna  
Battery Pack  
Wind Gauge Flag  
1
6
7
8
9
Spare Propeller  
Vertical Stabilizer  
Display Stand  
Horizontal Stabilizer  
Battery Cover  
2
3
1
1
1
1
1
2
1
3
4
5
10  
PLEASE READ THE FOLLOWING CAREFULLY  
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS MANUAL AS A REFERENCE  
TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY  
KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE OR SHE IS  
QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY  
STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED  
TECHNICIANS AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER  
REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION  
OF REPLACEMENT PARTS THERETO.  
Note: Some parts are listed and shown for illustration purposes only and are not available  
individually as replacement parts.  
SKU 98480  
For technical questions please call 1-800-444-3353.  
Page 7  
 

Graco Car Seat ISPC014BB User Manual
Grundig Grinder CUC 7301F User Manual
Guardian Technologies Telephone HR70 User Manual
Haier Washer Dryer HWM65 828 User Manual
Harbor Freight Tools Nail Gun 99640 User Manual
Healthrider Home Gym HREX36500 User Manual
Hotpoint Washer HAULT 943 User Manual
HP Hewlett Packard All in One Printer 1150Cse User Manual
HP Hewlett Packard Computer Accessories BC767A User Manual
HP Hewlett Packard Power Supply R2200 User Manual