Casio Clock TQ 309 User Manual

MA0411-EA  
Operation Guide TQ-309  
ILLUSTRATION  
SETTING THE TIME  
1. Load the battery, making sure its ends are facing as shown in the illustration.  
2. Remove the battery to stop the Second hand (4) at 12 o’clock position.  
3. Pull out the Time/Alarm setting knob (7) and rotate it to set the time.  
Note that this clock does not distinguish between AM and PM times.  
4. After setting the time, push the Time/Alarm setting knob (7) back to its original position.  
5. Replace the battery at a time signal to restart the Second hand (4) on the correct second.  
The start of Second hand (4) may be delayed depending on when you load the battery.  
12  
6
ON  
11  
10  
1
5
2
4
USING THE ALARM  
3
9
When the alarm is turned on, the alarm sounds for 60 minutes at the preset time each day. Once the alarm starts to  
sound, you can switch it off by pressing the Alarm ON/OFF switch (6).  
OFF  
8
7
Setting the Alarm Time  
1. Making sure the Time/Alarm setting knob (7) is not pulled out, rotate the knob to move the Alarm hand (5)  
counterclockwise to the setting you want.  
1
2. Raise the Alarm ON/OFF switch (6) to turn on the alarm.  
Note that this clock does not distinguish between AM and PM times. If you set an alarm to wake up to in the  
morning, the alarm will sound again at the same time in the evening if you leave the Alarm ON/OFF switch (6)  
raised.  
Stopping the Alarm  
2
While the alarm is sounding, press the Light/Snooze button (1) to stop it.  
The snooze alarm remains activated for about 60 minutes. During that time, the alarm will sound again about four  
or five minutes after you press the Light/Snooze button (1) to stop the current alarm.  
Pressing the Light/Snooze button (1) also turns on display illumination.  
The alarm will not sound if the Alarm ON/OFF switch (6) is in the OFF position.  
LUMINOUS FACE  
Special plastic is used for numerals and face markings to make them appear to glow.  
BATTERY REPLACEMENT  
Low battery power is indicated when timekeeping slows or stops completely. Should either of these symptoms  
occur, replace the battery as soon as possible. Do not leave a low or dead battery in the clock.  
1. Open the Battery cover (0) as shown in the illustration.  
A sticker is affixed to the glass of this clock when you purchase it. Be sure to remove the sticker before using the  
clock.  
Depending on its model number, the appearance of your clock may differ somewhat from that shown in the  
illustration.  
2. Remove the old battery.  
3. Load a new battery. Make sure that its positive (+) and negative (–) ends are facing correctly.  
4. Replace the Battery cover (0).  
GENERAL GUIDE  
1 Light/Snooze button  
Hold down to illuminate the display.  
Pressing this button while the alarm is sounding stops the alarm.  
Battery precautions  
Keep batteries out of the reach of small children. If a battery is accidentally swallowed, contact your physician  
immediately.  
Be sure to load the battery with its positive (+) and negative (–) ends facing correctly.  
Never charge the battery that comes with the clock.  
2 Hour hand  
3 Minute hand  
4 Second hand  
5 Alarm hand  
Should a battery ever leak while in the clock, wipe out the fluid with a cloth, taking care not to let any get onto  
your skin.  
Replace the battery at least once a year, even if the current battery is working normally.  
The battery that comes with the clock loses some power during transport and storage.  
6 Alarm ON/OFF switch  
7 Time/Alarm setting knob  
Press in and rotate to set the alarm.  
Pull out and rotate to set the time.  
8 Battery  
9 Catch  
0 Battery cover  
1
 

Belkin Computer Drive F5U237 User Manual
Black Decker Kitchen Utensil EK100 User Manual
Bravetti Mixer EP559 User Manual
Brinkmann Gas Grill Charcoal Gas Grill User Manual
Canon Camera Lens 2540A002 User Manual
Canon Printer QY8 1360 000 User Manual
Carrier Air Conditioner 53MX User Manual
Carson Stereo Amplifier SA 400 17 User Manual
Casio Digital Camera QV R3 User Manual
Casio Watch 1874 1 User Manual