CDA Refrigerator FF150 User Manual

FF150 freestanding under  
counter larder fridge  
with ice box  
Manual for Installation, Use and Maintenance  
Customer Care Department • The  
Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY  
T : 01949 862 012 F : 01949 862 003 E : [email protected] W : www.cda.eu  
 
Before first use  
You must allow the fridge to settle for at least twenty four hours prior to switching the power on.  
It is recommended that you clean the interior of the appliance prior to first use, using a solution of bicarbonate of soda  
and warm water and then thoroughly drying the interior.  
The fridge may have an odour to it at first use. This will disappear as the appliance cools.  
Please note:  
The appliance will work continuously until it comes down to the correct temperature.  
If the appliance is switched off, you should allow five minutes before switching it on again to prevent unnecessary  
damage to the compressor.  
This appliance must never be installed close to heat sources, e.g. heating elements, cookers or in damp places.  
The plug should be fully accessible at all times.  
To ensure the appliance is level, you should use the height adjustable feet at the front of the appliance.  
The cooling system at the rear of the appliance must not touch the rear wall.  
The appliance must be installed with adequate ventilation. Ensure that there is 15 cm clearance above the appliance,  
and that there is space between the rear of the appliance and the wall.  
Reversing the door  
It is possible to reverse the door on this refrigerator, if required. To do so, follow the steps below:  
1. Carefully tilt the appliance to allow access to the base of the appliance.  
2. Remove the height adjustable feet.  
3. Remove the lower hinge plate.  
4. Lift off the door and carefully put it to one side.  
5. Remove the top hinge plate. Change the hinge pin on the plate over and then replace the hinge plate on the  
alternate side of the door frame.  
6. Remove the hinge pin receiver and blank at the top of the door and replace on the alternate side.  
7. Relocate the door on the top hinge pin.  
8. Refit the lower hinge plate.  
9. Refit the height adjustable feet.  
 
Setting the temperature  
The temperature is regulated by the thermostat dial, found inside the fridge compartment on the right hand side.  
The thermostat can be adjusted between 1 (least cold) and 5 (coldest).  
To switch off the cooling system, turn the thermostat to 0.  
thermostat  
light bulb cover  
Use  
Never put liquids in the refrigerator uncovered.  
Never put hot foods in the refrigerator. Warm food should be allowed to cool to room temperature before being put  
into the refrigerator.  
Nothing should rest against the internal rear wall of the refrigerator, as this will cause frost and possible condensation  
problems which will be difficult to remove.  
Using the ice box  
The ice-box door is fitted with an indicator to show whether the door is fully closed. The door should be kept closed to  
prevent the contents of the ice-box defrosting, heavy build up of frost in the ice-box and excessive unnecessary use of  
energy. The indicator is shown in the diagram to the right.  
The Door Open indicator shows red when the door is not closed properly.  
The Door Open indicator shows white when the door is fully closed.  
 
Care and cleaning  
Always disconnect the appliance from the power before any cleaning or maintenance.  
The refrigerator section should be cleaned using a solution of bicarbonate of soda and lukewarm water.  
Do not use abrasive products or detergents. After washing, rinse and dry thoroughly.  
Clean the shelves and balconies separately by hand using soap and water. Do not put them in the dishwasher.  
The evaporating tray and water drain hole (at the back of the refrigerator compartment) should be cleaned  
periodically to prevent the defrosted water from collecting inside the refrigerator compartment. The drain  
plug can be used to clear the drain hole.  
Once cleaning is complete, then reconnect the power.  
If the appliance is not used for prolonged periods of time, unplug and clean the appliance. The doors should be left  
slightly open to prevent the formation of mildew and smell.  
Defrosting the fridge  
The fridge is self-defrosting. Any water created will run out of the fridge through the channel at the back of the fridge.  
It is important to keep the channel clear at all times. The defrosted water is collected in the evaporating tray at the back  
of the appliance.  
Defrosting the ice-box  
The ice box should be defrosted regularly to ensure the most efficient running, at a minimum of once every  
six months.  
Do not use heaters or defrosting sprays in this appliance.  
Never use any metallic or sharp objects to remove the ice as this could damage the lining.  
To speed up the process, put a bowl of warm water in the base of the ice-box compartment.  
Once defrosting is complete, dry the inside of the ice-box with a sponge or clean cloth.  
To bring the unit back to temperature more quickly set the thermostat to 5 after defrosting.  
Changing the light bulb  
Disconnect the appliance from the power.  
Remove the light cover by pressing the grooves on both sides of the cover and then lifting away.  
Unscrew the light bulb to remove it and replace with a new bulb (not more than 15W).  
Replace the light cover and reconnect the power after five minutes’ delay as explained on page 3.  
 
Troubleshooting  
If you have any problems with your appliance, you should check the troubleshooting prior to calling CDA Customer Care  
to prevent unnecessary service calls and potential cost.  
If the appliance is not working  
Check there is power to the appliance:  
The house fuses are intact and the fuse in the plug has not blown.  
The thermostat is not set to 0 (off position).  
The plug socket is functioning fine. To check this, plug another electrical appliance in to see if the socket is working.  
The temperature of the room is adequate (10oC or above).  
The appliance is working, but not very well  
The appliance is not overloaded.  
The thermostat is set to an appropriate temperature.  
The door is closing properly.  
The cooling system at the rear of the appliance is clean and free of dust, and not touching the rear wall.  
There is enough ventilation at the side and rear walls.  
The temperature of the room is adequate (10oC or above).  
The appliance is noisy  
The appliance is level and stable.  
The side and rear walls are clear, and there is nothing resting on the appliance.  
The cooling gas in the refrigerator will make a slight bubbling noise, even when the compressor is not running.  
There is water in the lower part of the refrigerator compartment  
The drain hole in the channel at the back of the compartment is clear.  
 
Electrical information  
Warning! This appliance must be earthed.  
The mains lead of this appliance has been fitted with a BS 1363A 13 amp fused plug. To change a fuse in this type of plug,  
follow the steps below:  
1. Remove the fuse cover and fuse.  
2. Fit replacement 13A fuse, ASTA approved to BS 1362 type, into the fuse cover.  
3. Replace fuse cover.  
Important: Do not use the appliance without the fuse cover in position.  
How to connect an alternative plug  
If the fitted plug is not suitable for your socket outlet, then it should be cut off and disposed of safely to avoid possible shock  
hazard. A suitable alternative plug of at least 13 Amp rating to BS 1363 should be used.  
As the colours of the wires in the mains lead of this appliance may not correspond with the  
coloured markings identifying the terminals in your plug, proceed as follows:-  
The wire which is coloured GREEN and YELLOW must be connected to the terminal which is marked with letter (E) or  
by the Earth symbol or coloured GREEN and YELLOW.  
The wire which is coloured BLUE must be connected to the terminal which is marked with the letter (N), or  
coloured BLACK.  
The wire which is coloured BROWN must be connected to the terminal which is marked with the letter (L) or  
coloured RED.  
If in doubt regarding the electrical connection of this appliance, consult a qualified electrician. Do not shorten the  
supply cable, the appliance may require removing for servicing.  
N.B. Ensure that the plug socket is situated in an easily accessible place.  
 
To contact our Customer Care Department, or for Service,  
please contact us on the details below.  
Customer Care Department • The  
Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY  
T : 01949 862 012 F : 01949 862 003 E : [email protected] W : www.cda.eu  
 

Belkin Laptop Docking Station P73326 F5U120 PC User Manual
Black Decker Laser Level BDL220S User Manual
Bosch Power Tools Laser Level GCL25 User Manual
Briggs Stratton Lawn Mower 2400 XL User Manual
Briggs Stratton Lawn Mower 5900301 User Manual
Cadence Treadmill WETL21021 User Manual
Canon All in One Printer PIXMA MG5220 User Manual
Casio Musical Instrument LK300TV User Manual
Chamberlain Garage Door Opener RDO800 User Manual
Chromalox Gas Heater PE436 User Manual