Please Read
Ikelite Digital Housing
We suggest that you read this instruction booklet thoroughly
before use. If you are new to underwater photography be sure
to read the General and Photo Tips.
i n s t r u c t i o n m a n u a l
#6138.12 for Olympus Stylus 1200, Mju1200
We also suggest that you read the camera manual thoroughly
to have a full understanding of where each camera control is
located and what function each control provides.
Please Read If Using an EV-Controller
The EV-Controller used with Ikelite DS Substrobes have two
user settings. One setting is for strobe selection, the other is for
This camera uses pre-flash
, thus the
pre-flash or non pre-flash.
EV-Controller should be set to the pre-flash position when used
with this camera.
Congratulations on your purchase of an Ikelite Digital Camera
Housing. Ikelite has over 45 years of experience in the underwater
photographic and lighting market. Our products are designed and
built in the USA by Ikelite for both the professional and amateur
photographer.
The clear housing permits instant visual inspection of the camera
and all sealing surfaces as well as complete monitoring of controls
and camera LCD screens.
Ikelite Digital Housings are slightly negative in salt water for
stability. This housing has been water pressure tested at the
factory. Housing is pressure tested to 200' (60m).
2
Opening the Housing
Power
Push Forward
Lock
1. Lid Snaps have a
.
Lid Snap Lock
To open, push Lid Snap Lock
forward and lift as shown.
Keep pressure on the Lid Snap
so it does not fly
Shutter
Release
Lift
open quickly.
Some lid snaps have a lot
Lid
Snap
Lid
Snap
of spring tension once they go over center, have a firm grip
on the lid snap. Lid Snaps may be opened one at a time.
Lens
Port
Installing the Camera
1. Remove the back from the housing. The mounting tray for the
camera is secured to
the housing back.
O' Ring
Position the camera
Front View
on the tray and
secure it with the
Lid
Hook
mounting bolt which
Thumb
Rest
threads into the
camera's tripod
socket. Use
Zoom
a coin or flat bladed
Mode Dial
Mounting
Tray
screwdriver to
Mounting Bolt
tighten the mounting
bolt so the camera is
Menu
flat against the tray.
Lanyard
Arrow Pad Buttons
Display
CAUTION:
Play
Flash
Some camera tripod socket threads are plastic. The mounting
tray bolt is metal. Do not cross thread or over tighten as you
may damage the camera tripod socket threads.
Erase
3
4
|