Samsung Washer SW T65B1P User Guide

WASHING MACHINE  
Owner’s Instructions  
SW-T65A1(P) / SW-T65B1(P) / SW-T65C1(P)  
FEATURES  
PRECAUTIONS  
1
1
DESCRIPTION AND CLEANING OF PART 2  
CLEANING THE MACHINE  
CONTROL PANEL  
WASHING PROCEDURE  
To Wash  
To Spin Dry  
To Rinsing  
2
2
3
3
3
3
3
4
4
4
4
4
5
5
5
Overflow rinse  
Additional rinse  
INSTALLATION  
Location  
Connecting the drain hose  
Mounting the legs  
LAUNDRY GUIDE  
MAINTENANCE  
TROUBLE SHOOTING  
Before operating the washing machine, please read this manual  
thoroughly, and retain it for future reference.  
 
DESCRIPTION AND /CLEANING OF PARTS  
.
CLEANING THE FILTER  
Pull the overflow filter out and take up  
the filter by removing 3 screws as  
shown in figure. Wash the filter and  
washing tub.  
SPIN DRYER LID  
When you open this  
INNER LID  
lid while the spin basket is  
spinning,the spinning will  
be stopped by the brake  
system.  
CLEANING THE FILTER  
DRAIN HOSE  
Push the strainer(filter) out and take  
SPIN DRYER BASKET  
(with pump)  
up the filter as shown in figure.  
Wash the filter and washing tub.  
POWER CORD  
The plug’s shape  
may not be similar to that  
shown in this drawing.  
OVERFLOW  
FILTER  
LINT FILTER  
This is used for  
gathering the  
DRAIN FILTER  
In case of incomplete drain,  
disassemble the drain filter with  
screw driver(+), and remove  
lints from the filter as shown  
in the filter as shown in  
the figure.  
dregs made during  
washing.  
WATER DRAIN HOSE  
(without pump)  
WASH TUB LID  
Be sure to keep  
the lid closed  
EARTH WIRE  
during washing  
and spinning.  
HOW TO CLEAN THE FILTER  
(In case drain pump)  
1. Place a rag under the washer filter  
not to wet the floor.  
WASH TUB  
PULSATOR  
DRAIN FILTER  
2. Rotate the filter counterclockwise  
and pull out the filter.  
3. Remove dirts and  
rotate the filter  
clockwise until it  
locks in position.  
OVERFLOW FILTER  
Pull the upper side of the  
overflow filter with your  
fingers into the holes  
in the direction of  
CLEANING THE LINT FILTER  
If the dregs are piled up in the  
lint filter after finishing the wash,  
push down and  
OVERFLOW FILTER  
Pull the upper side of the  
overflow filter with  
two fingers inserted into  
hole ‘A’ in the  
A
pull it out as  
direction of arrow  
arrow as shown  
shown in the  
as shown in the figure.  
in the figure.  
figure.  
Wash the filter  
net in water.  
CLEANING THE WASH TUB  
First, fill water in the wash tub to ‘L’ level(  
, then drain water from the wash tub simultaneously with  
operating wash cycle for 1~2 minutes. Close the wash tub lid.  
2
 
WASHING PROCEDURE  
TO WASH  
TO SPIN DRY  
TO RINSING  
1. Before starting to wash, proceed as follows,  
Connect the water supply  
1. Transfer the clothes into the  
spin basket and arrange the  
clothes evenly.  
1. Set the cycle selector KNOB to  
‘WASH.RINSE’.  
Wash/Rinse  
Wash  
hose and open the water tap.  
• Lay the drain hose down toward  
a sinkhole. (In case no drain pump)  
• Place the drain hose in sink or bath.  
(In case no drain pump)  
(In the case of  
Drain Rinse  
Drain  
drain pump  
‘WASH’)  
CYCLE SELECTOR  
CYCLE SELECTOR  
2. Be sure to replace the safety  
cover and close the  
inner lid  
2. Supply the proper amount of water  
so as not to delete one space overflow  
the top of the washing tub.  
• Connect the power cord to the power  
supply outlet.  
inner lid.  
safty cover  
0
Soft  
Normal  
15  
3
6
2. Set the WASH SELECTOR  
KNOB to the desired mode.  
3. Set the WASH TIMER to  
2~3 minutes.  
12  
9
WASH SELECTOR  
Wash Spin  
3. Close the spin  
dryer lid.  
WASH TIMER  
3. Set the WTER SELECTOR  
KNOB to the desired mode.  
(FOR SW-T65B1, SWT65C1)  
4. Drain the water. Set the delete  
one space cycle selector  
KNOB to ‘DRAIN’.  
WATER SELECTOR  
4. Set the CYCLE SELECTOR KNOB to  
“WASH.RINSE”.(in case drain pump WASH)  
5. Repeat this cycle until drain  
water is clean. (2~3 cycles)  
0
3
4. Set the SPIN DRY  
TIMER 1-5minutes.  
5
4
1
2
Wash/Rinse  
Wash  
Drain Rinse  
Drain  
SPIN DRY TIMER  
OVER FLOW RINSE  
CYCLE SELECTOR  
CYCLE SELECTOR  
Wash/Rinse  
Wash  
1. Keep supplying  
5. Fill water in the wash tub  
and add the detergent.  
Drain Rinse  
Drain  
water(adjust water  
pressure to ensure  
that the amount of  
water supplied does not exceed the amount  
of water drained.)  
CYCLE SELECTOR  
CYCLE SELECTOR  
6. Load laundry in the  
wash tub and fill water  
to proper water level.  
0
15  
12  
3
6
2. Set the WASH TIMER  
6~8 minutes.  
7. Set the WASH TIMER  
1-15 minutes.  
0
15  
12  
3
6
9
WASH TIMER  
3. As soon as the  
WASH TIMER  
shuts off, turn off  
the water tap.  
0
8. After washing, set the CYCLE  
SELECTOR  
9
15  
3
WASH TIMER  
KNOB to 'DRAIN' for drain.  
12  
6
9
WASH TIMER  
4. Set the CYCLE  
SELECTOR KNOB  
to ‘DRAIN’.  
3
 
INSTALLATION  
CHANGING THE POSITION  
OF THE DRAIN HOSE  
ADDITIONAL RINSE  
LOCATION  
Leave some space of  
at least 15cm between the washing machine  
and the wall.  
1 After rinsing you can select this  
course for more effective rinse  
(Don't just select this course  
for rinse.) Load the laundry  
evenly into the spin basket.  
Before attempting to change the position of the  
drain hose, disconnect the plug from the outlet.  
Place the washing machine on a sturdy flat 1. Route the drain hose inside the machine.  
surface.  
2.Take out the drain hose from the opposite hole  
and insert the drain hose into the hose holder.  
If the washer is placed on an uneven or weak  
surface, noise or vibration may be occured.  
(Allowable is 2˚)  
2 Set the WATER SELECTOR  
KNOB to SPIN and  
Wash  
Spin  
CYCLE SELECTOR  
KNOB to DRAIN.  
Never install the washing machine near water.  
Do not place the washing machine in steamy rooms  
or where the washing machine is directly exposed  
to rain. Moisture may damage electrical insulation  
and cause an electrical shock to occur.  
Avoid direct sunlight or heating devices.  
As plastic and electrical components are affected  
by direct heat, never place the washing machine  
near heaters, boilers, etc., or under direct sunlight.  
WATER SELECTOR  
2
1
3 Supply water for about 1 minute.  
Adjust the water flow to prevent  
overflow from the wash tub.  
Hose holder  
CONNECTING THE DRAIN HOSE  
After attaching the connector ring(a), insert  
the drain hose(b) in the draining direction.  
4 After completing the water supply,  
cover the laundry with  
safety cover and close  
the inner lid.  
inner lid  
safety  
cover  
a
Install the drain hose  
b
about 70~80cm above  
the ground for pump model.  
5 Close the spin dryer lid.  
0
6 Set the SPIN DRY  
TIMER 2~3 minutes.  
CONNECTING THE DRAIN HOSE  
1. Before connecting the drain hose, remove  
the cover (a) from the drain hole.  
2. After pressing the joint ring (b), insert the  
drain hose(c) to drain direction.  
5
1
2
MOUNTING THE LEGS  
4
Lay down the washer with its back facing  
downward. Insert four legs into the leg mounting  
sections of the base corners of the main body.  
3
SPIN DRY TIMER  
Claw  
Insert the claw of the  
leg with the square  
hole of the leg  
Square  
hole  
2
1
mounting section,  
and push the leg in  
the arrow direction  
(a)  
(C)  
(C)  
(b)  
(b)  
(In case of pump  
drained washer)  
as shown in the  
figure until it clicks.  
Leg  
Bottom face of  
main body  
4
 
LAUNDRY GUIDE  
MAINTENANCE  
TROUBLE SHOOTING  
TO LOAD THE LAUNDRY INTO  
THE SPIN BASKET.  
Press the laundry evenly and put the safety  
cover into the spin basket as shown in the  
figure.  
WASHING TIME  
TROUBLE  
CHECK POINT  
WASHING  
SELECTION  
WASHING TIME  
TYPE OF CLOTHING  
The washing  
machine does connected to a power outlet.  
not work.  
Check that the power cord is properly  
10 to15 minutes  
Extremely soiled  
heavy fabric  
Is there a power failure?  
Is the machine overloaded?  
NORMAL  
Clothes do  
Linen, cotton, etc.  
not move freely.  
8 to10 minutes  
7 minutes  
Is the laundry arranged  
evenly?  
Incomplete  
spinning  
Ordinary clothes  
(underwear,etc)  
Is the filter clogged with lint?  
See Cleaning of parts.  
Slightly soiled  
synthetic fiber  
Incomplete  
draining  
2 to 5 minutes  
SOFT  
100% wool, mixed wool knitting,  
thin synthetic fiber with  
2 to 5 minutes  
TO RETRIEVE THE CLOTHING THAT HAS  
FALLEN BETWEEN THE BASKET AND TUB.  
For safety reason, pull the power supply plug out of the  
socket.  
1. Unscrew the spin dryer hatch.  
2. The spin dryer hatch is  
fixed to the brim by the  
concave and convex  
parts at two places.  
Expand the concave and  
Is the spin dryer lid closed  
completely?  
Are laundry items (socks, etc.) falling  
out of the spin dryer basket and  
clinging to the axle?  
The spin dryer  
basket will not  
run.  
tags indicating hand washing  
SPIN DRY TIME  
TYPE OF FABRIC  
Thin (synthetic fiber)  
TIME  
1 min.  
See To retrieve...on page 5.  
wool  
cotton  
1~2 min.  
3~5 min.  
5 min.  
AFTER OPERATION  
1. Remove the power cord from the outlet.  
2. Take out the laundry.  
thick (cotton)  
convex parts,and pull up  
the spin dryer hatch to  
3. Close the water tap and disconnect the water  
supply hose.  
DETERGENT  
WATER  
LEVEL  
AMOUNT OF  
DETERGENT  
remove it.  
3. Retrieve the clothing.  
4. Close the spin dryer hatch. Push the hatch  
firmly until the catch at the front is securely  
attached.  
4. Clean the washing machine.  
- Periodical cleaning will extend the life of your  
washing machine.  
- Do not spray the unit water or use tinner, benzene,  
alcohol etc, for cleaning it.  
The amount of detergent  
is average. Follow the  
instruction printed on the  
package for amount of  
detergent. Choose the  
amount of detergent  
Low (30l)  
30g  
40g  
50g  
Medium (40l)  
High (50l)  
according to the fabric type.  
DETERGENT  
In case the water level is at High,  
amount of water is 42l.  
-H-  
Follow the directions printed on the package  
for amount of detergent. Choose the amount of  
detergent depending on the fabric type and  
water level.  
CLEANING THE WASHING MACHINE  
Wipe off stains on the cabinet and operation pane  
with a soft cloth. Neither use benzene, thinner,  
cleanser, or wax, nor scrub the washing machine  
with a brush. Painted surfaces or plastic parts will  
be damaged.  
5
 
SPECIFICATIONS  
DIMENSIONS  
SW-T65A1P  
SW-T65B1P  
SWT65C1P  
776 434 844 mm  
776 444 953 mm  
776 434 941 mm  
WATER PRESSURE  
WEIGHT  
0.05~0.78 MPa(0.5~8.0 Kg  
SW-T65A1(P)  
SW-T65B1(P)  
SWT65C1(P)  
24Kg(26Kg)  
26Kg(28Kg)  
26Kg(28Kg)  
EXTRACTION EFFICIENCY  
STANDARD QUANTITY OF WATER  
RATING TIME  
50 %  
50 l  
Washing 1 Hour / Spinning 15 minutes  
DC68 - 00099A-01  
 

Q See Lawn Mower QT17D324SC User Guide
RCA DVD Player RC6001P User Guide
RCA Universal Remote RCR 3283 User Guide
Renesas Network Card M3T 100LCC QSD User Guide
Ricoh Network Card AR B1045 User Guide
Roberts Radio Portable Radio R761 User Guide
RocketFish Power Supply RF BSLAC User Guide
Rotel Stereo System RT 824 User Guide
Sanyo DVD Player DC TS762 User Guide
Scientific Atlanta Satellite TV System 4001534 User Guide