Rosewill Computer Hardware RX81U ES User Guide

[ RX81U-ES Series ]  
2.5” External Enclosure  
User Manual  
 
2.5” External Enclosure [ RX81U-ES Series ]  
User Manual  
Hardware Installation:  
1. Press and slide out the cover to the enclosure  
2. Carefully connect the hard drive to the connector from the internal board. Fasten hard drive onto the slide tray with  
four screws included  
3. Connect USB Y cable (main A /B) to an available port on your computer.  
*When Main A can not supply enough power to initiate hard drive, please connect Aux. A to get extra power.  
4. Windows will find new hardware and install the appropriate drivers  
5. Hardware installation is complete  
Software Installation:  
Windows ME/2000/XP/Vista  
If you are running Windows Me, Windows 2000, Windows XP, Vista or Mac OS X, you DO NOT need to install a driver or  
any software from the included CD. Simply plug the driver enclosure to the computer and it will be detected automatically.  
- Install the drivers for Windows98/98SE  
1. Insert the Driver CD into your computer’s CD-ROM or compatible optical drive.  
2. Double click the My Computer icon on the desktop. Double click the icon for the computer’s CD-ROM drive  
3. Locate and open the \Win98 folder. Double click on the Setup.exe file, and follow all prompts to complete installation  
4. Once the software installation has completed, connect the enclosure to the host computer using the included USB  
cable. Windows will notify you that new hardware has been found and installed.  
Partition and Format  
Under Windows 2000/XP/Vista  
You can partition and format the drive via USB using the Logical Disk Manager utility. Click Start, then Run.  
Type diskmgmt.msc, and click Ok. This will start the utility. The USB drive should be visible in the bottom panel.  
Once you have partitioned and formatted the drive, Windows will assign it a drive letter and it is ready to use.  
Under Windows 98/Me  
1. Go to MS-DOS mode by click Start, then Programs, then MOS-DOS Prompt  
2. Type “FDISK” (without quote) and press enter  
3. If FDISK quit without any message, go back to the Windows 98 screen, plug out the USB Hard Drive, re-boot computer,  
plug in USB Hard Drive again and go to step 1 to proceed.  
4. In the first screen of FDISK, answer the question:  
DO YOU WANT TO ENABLE LARGE DISK SUPPORT?  
Y if you want to build a partition larger than 2GB  
N if you want to build a partition smaller than 2GB  
5. The next screen is FDSIK OPTIONS, type “5” to select disk  
3
 
2.5” External Enclosure [ RX81U-ES Series ]  
User Manual  
Disconnecting the hard drive enclosure  
Windows 98SE  
Simply unplug the USB cable connecting the enclosure to the host computer  
Windows ME/2000/XP/Vista  
1. Right click on the removable storage icon located in the task bar.  
Windows XP/Vista: When the safely Remove Hardware message appears, click on it with the left mouse button.  
Windows ME/2000: When the unplug or eject hardware message appears, click on it with the left mouse button  
2. You will be asked to select the device you wish to disconnect. Please highlight the drive listing, and click on OK.  
3. On the screen that follows, click on Stop.  
4. Wait for the message indicating that it is now safe to remove the device. Please note: Removing the connected drive  
prior to receiving notification that it is safe to do so, could result in losing or corrupting data stored on the drive. Once  
the safe to Remove Hardware message appears, please disconnect the enclosure from the computer by removing  
the USB connection.  
Mac  
To safely disconnect the attached drive from the host computer, close any windows listing the contents of the removable  
drive. Once all windows are closed, click on the USB storage icon on the desktop, and drag it to the Trash Can icon on  
the desktop. Allow 5 seconds before physically removing the enclosure/drive from the computer  
4
 
2.5” External Enclosure [ RX81U-ES Series ]  
User Manual  
RX81U-ES-25A : Specifications  
Hard Drive support  
Connectors  
2.5” SATA  
USB mini B Female  
250GB, 5400RPM  
480Mb/s  
Drive Capacity support  
Maximum Data Transfer Rate  
Chipset  
JM20329  
Operation System support  
Windows 98SE/ME/2000/XP/Vista  
Mac OS 9.2 or higher  
130*75*15mm  
Dimensions  
Weight  
100g  
Regulatory Certifications  
CE,FCC, ROHS  
RX81U-ES-25B : Specifications  
Hard Drive support  
Connectors  
2.5” IDE  
USB mini B Female  
250GB, 5400RPM  
Support up to 480Mb/s  
M110 (MOI)  
Drive Capacity support  
Maximum Data Transfer Rate  
Chipset  
Operation System support  
Windows 98SE/ME/2000/XP/Vista  
Mac OS 9.2 or higher  
130*75*15mm  
Dimensions  
Weight  
100g  
Regulatory Certifications  
CE,FCC, ROHS  
Thank you for purchasing a quality Rosewill Product.  
5
 

Radio Shack Scanner PRO 2015 User Guide
RCA Modem TCM XXX User Guide
ResMed Respiratory Product C16389 User Guide
RocketFish Speaker System RF 2990 User Guide
Roland Musical Instrument FP 3 User Guide
Rotel Power Supply RB 951 MkII User Guide
Samson Music Mixer Mixpad 12 User Guide
SanDisk Computer Accessories SDDR 300 User Guide
Seagate Computer Monitor ST136475LW LC User Guide
Sears Cultivator 3162927 User Guide