Pioneer Home Theater System HTZ232DVD User Manual

Setting up your DVD/CD Receiver  
When connecting this system or changing connections, be sure to switch the power off with the STANDBY/ON button, and disconnect the power cord from the AC outlet.  
Do not use these speakers with any other system or amplifier as this may result in damage or fire.  
Using the remote control  
Additional notes on connecting antennas  
Keep antenna cables away from the main unit and other  
cables.  
To assure optimum reception, pull the FM antenna so that it is  
fully extended and not coiled or hanging at the rear of the unit.  
If reception with the supplied antenna is poor, see the Other  
connections section in the main operating instructions for  
Check that you have all the accessories, then put  
the batteries in the remote control.  
Connect the AM and FM antennas to the rear panel of the DVD/CD receiver.  
The remote control can be used within a range of about 7  
meters from the remote sensor on the front panel, and  
within a 30 degree angle.  
2
1
Precautions:  
The remote control may not work if there is an obstacle  
between the remote control and the display unit, or if the  
remote control is not directed towards the remote sensor  
of the display unit at the correct angle.  
The remote control may not work properly if strong  
light such as direct sunlight or fluorescent light is shining  
onto the units remote sensor.  
The remote control may not work properly when this  
unit is used near devices emitting infrared rays, or when  
remote controls of other devices which use infrared rays  
are used. Also, the use of this remote control may cause  
other devices to work improperly.  
Batteries and  
remote control  
Pull off the protective  
1
shields of both AM antenna  
details on connecting outdoor antennas.  
Power cord *  
fig. A  
fig. B  
fig. C  
wires.  
STANDBY/ON  
DVD/CD  
MUTE  
Additional notes on speaker placement  
* In some countries or regions, the shape of the  
power plug may sometimes differ from that  
shown in the explanatory drawings.  
FM/AM  
TUNER  
LINE  
If your listening room is of adequate size, place the speakers as  
shown in step 3 to achieve the optimum surround sound effect.  
If you are listening in a fairly small room and a typical surround  
speaker setup is not possible, see Home theater sound setup in  
the instruction manual and the Speaker Setup Guide for  
information on the Front Surround 3-spot setup option.  
When using the standard surround speaker setup as shown in  
step 3, please observe the following guidelines:  
1
4
7
2
5
8
3
6
9
4
Push open the tabs, then insert  
2
3
VOLUME  
one wire fully into each terminal.  
0
AUDIO SUBTITLE ANGLE  
ZOOM  
HOME  
MENU  
DVD  
MENU  
TUNE  
SYSTEM  
SETUP  
TOP  
MENU  
6
ST  
ST  
Video cord  
ENTER  
TUNE  
Release the tabs to secure the AM  
antenna wires.  
SOUND  
MODE  
RETURN  
TEST TONE  
When the operating range of the remote becomes too  
Install the main front left and right speakers at an equal  
distance from the TV.  
For optimum effect, install the rear speakers slightly above  
ear level.  
short, replace the batteries.  
1
CLEAR  
SLEEP DISPLAY  
ANTENNA  
Fix the AM loop antenna to the  
attached stand.  
Remote control battery caution  
Incorrect use of batteries may cause leakage or  
rupture.  
SHIFT  
SURROUND FRONT  
SURROUND  
2
4
Install the center speaker above or below the TV so that the  
3
To fix the stand to the antenna, bend in the  
direction indicated by the arrow (fig. A) then  
clip the loop onto the stand (fig. B).  
FM antenna  
sound of the center channel is localized at the TV screen.  
Always be sure to follow these guidelines:  
FM  
AM  
UNBAL 75  
LOOP ANTENNA  
Always insert batteries into the battery compartment  
Precautions:  
AM loop antenna  
correctly matching the positive ª and negative ·  
polarities, as shown by the display inside the  
compartment.  
depending on brand. Do not mix different brands of  
batteries.  
governmental regulations or environmental public  
instruction's rules that apply in your country or area.  
batteries when not using the remote control for an  
extended period (one month or more). If leakage occurs,  
carefully wipe away any battery fluid inside the  
When installing the center speaker on top of the TV, be sure  
to secure it with tape or some other suitable means.  
Otherwise, the speaker may fall from the TV due to external  
shocks such as earthquakes, endangering those nearby or  
damaging the speaker.  
Note: If you plan to mount the AM antenna  
to a wall or other surface, secure the stand  
with screws (fig. C) before clipping the loop  
to the stand. Make sure the reception is clear.  
Never mix new and used batteries.  
Batteries of the same size may have different voltages,  
3
1
2
Do not connect the supplied speakers with any other  
amplifier. This may result in malfunction or fire.  
The front, center and surround speakers supplied with this  
When disposing of used batteries, please comply with  
Place the AM antenna on a flat  
surface and point in the direction  
giving the best reception.  
Don’t let it come into contact with metal  
objects and avoid placing near computers,  
television sets or other electrical appliances.  
5
6
Connect the FM wire antenna to the FM UNBAL 75antenna terminal.  
For best results, extend the FM antenna fully and fix to a wall or door  
frame. Dont drape loosely or leave coiled up.  
system are magnetically shielded. However, depending on the  
installation location, color distortion may occur if the speaker  
is installed extremely close to the screen of a television set. If  
this happens case, turn the power switch of the television set  
OFF, and turn it ON after 15 to 30 minutes. If the problem  
persists, place the speaker system away from the television set.  
In order to prevent battery leakage, remove the  
Note: The signal earth (H) is designed to reduce noise that occurs when an  
antenna is connected. It is not an electrical safety earth.  
compartment, and replace the batteries with new ones.  
The subwoofer is not magnetically shielded and so should  
Do not allow books or other objects to rest on top of  
not be placed near a TV or monitor. Magnetic storage media  
(such as floppy discs and tape or video cassettes) should also  
not be kept close to the subwoofer.  
the remote control, since the buttons may be depressed,  
causing faster exhaustion of the batteries.  
Do not fix the front, center speakers and subwoofer to the  
wall or ceiling; they could cause injury if they fell.  
Connect each speaker as shown below.  
Connect each speaker using the color-coded speaker cords.  
Match them to the colored speaker terminals on the rear  
panel of the DVD/CD receiver.  
3
(Subwoofer connentions start from step 3)  
Color-coded wire  
(Connect to speaker)  
Connect the DVD/CD receiver to your TV, then connect the  
supplied power cord.  
Surround right  
(Grey)  
Surround left  
(Blue)  
4
Color-coded connector  
(Connect to rear panel)  
Connect one end to a video input on your TV.  
Use the supplied video cord.  
1
Twist and pull off the protective  
shields on each wire.  
1
Connect the other end to the video output of the DVD/CD receiver.  
This player is equipped with copy protection technology. Do not connect this  
player to your TV via a VCR using AV cables, as the picture from this player will not  
appear properly on your TV.  
2
Connect the wires to the  
2
speaker. Match the colored  
wire with the color-coded  
label (above the tabs), then  
insert the colored wire into  
the red (+) tab and the other  
wire with the black (–) tab.  
COMPONENT  
C
P
B
/
B
VIDEO OUT  
LINE  
OUT  
FRONT  
CENTER  
R
L
IN  
Listening position  
Connect the power cord to the AC inlet.  
C
R
/
3
VIDEO  
OUT  
L
L
P
R
VIDEO  
OUT  
Y
Subwoofer (Purple)  
R
R
SUB  
SURROUND R  
L
WOOFER  
VIDEO IN  
VIDEO  
SPEAKERS  
AUDIO  
Connect the other end to the  
3
COMPONENT  
CB/  
VIDEO OUT  
color-coded speaker terminals  
on the rear of the DVD/CD  
receiver (as shown at left).  
PB  
CR/  
VIDEO  
For the best surround sound, setup your speakers  
as above. The front left and right speakers should  
be about 1.82.7 m apart.  
A
OUT  
S-VIDEO  
OUT  
Y
Make sure to insert completely.  
VIDEO  
Upper three terminals  
The small lug at the wire-end of  
the speaker plug should face up  
or down depending on whether  
it's being plugged into one of  
the upper or lower three  
COMPONENT  
VIDEO OUT  
ANTENNA  
C
P
B
B
LINE  
OUT  
FRONT  
R
R
L
L
CENTER  
IN  
Center (Green)  
FM  
AM  
C
P
R
/
R
VIDEO  
OUT  
L
L
UNBAL 75  
LOOP ANTENNA  
S-VIDEO  
OUT  
Y
R
R
SUB  
AC IN  
SURROUND  
WOOFER  
VIDEO  
AUDIO  
SPEAKERS  
Front left  
(White)  
Front right  
(Red)  
These speaker terminals can be hazardous when live. When you connect or  
disconnect the speaker cables, to prevent the risk of electric shock, do not  
touch uninsulated parts before disconnecting the power cord.  
speaker terminals. Please make  
sure to connect correctly.  
Lower three terminals  
AC IN  
To AC outlet  
Congratulations! You're done setting up.  
Printed in  
<ARE7358-A>  
Assembling the speaker stands and securing your front speakers  
Speaker Setup Guide  
Attach the speaker stand bases to the stems using the screws provided.  
Before securing the base to the stand, thread the speaker wire through the holes provided on the  
base as shown below. Then, once you have aligned the stem and base, secure with the small  
screws at the points shown at right.  
What's in the box  
• Front speakers x 2  
• Center speaker x 1  
• Surround speakers x 2  
• Subwoofer x 1  
• Speaker cords:  
Non-skid pads (small) x 4  
Non-skid pads (large) x 4  
Front speaker stand bases x 2  
Screws (for bases) x 6  
Brackets x 2  
Red/White (Front speakers) 4m x 2  
Green (Center speaker) 4m x 1  
Blue/Grey (Surround speakers) 10m x 2  
Screws (for brackets) x 4  
Mounting brackets x 2*  
Screws (for mounting brackets) x 2*  
Safety precautions when setting up  
*Please refer to Wall-mounting the front and surround speaker system  
in the operating instructions for installation.  
When assembling the speakers, lay them down flat on their side to avoid  
accidents or injury. Make sure to use a stable surface when assembling,  
setting up, and placing the speakers.  
Switch Front Surround  
MODE OFF for 5-spot set  
Standard surround  
5-spot setup  
This is a standard multichannel surround sound speaker  
setup for optimal 5.1 channel home theatre sound.  
Attach the smaller non-skid pads to the base of the center speaker. The four large  
Connect the speaker system.  
3
1
2
Refer to the Setting up your DVD/CD Receiver (the other part of this setup  
guide) to connect the speakers properly. Place them as shown in the  
diagram at far left optimal surround sound.  
non-skid pads are for the subwoofer (as shown).  
Use the supplied adhesive to attach 4 pads to the base of center speaker and subwoofer.  
up.  
See the operating instructions for  
more on using Front Surround.  
Front right  
Front left  
Caution  
Please don't use the any attachments  
with the front speakers other than the  
brackets provided.  
Center  
Subwoofer  
Surround  
left  
Surround  
right  
Listening position  
Subwoofer  
Center speaker  
Front surround  
3-spot setup  
Attach the smaller non-skid pads  
to the base of the center speaker.  
The four large non-skid pads are  
for the subwoofer (as shown).  
Use the supplied adhesive to attach  
4 pads to the base of center speaker and  
subwoofer.  
Secure the speaker wire.  
Secure in position with the brackets provided.  
Place the surround speakers on top of  
the front speakers, turn the surround  
speakers towards the closest wall, lining  
the arrows up for optimal Front  
3
1
2
5
When you're finished, thread  
the surround speaker cords  
through the outlet on the back  
of the speaker stand and  
through the base of the  
Line up the holes in the bracket with the holes in the speakers, then  
secure with two screws at the points shown below. Make sure you've  
matched the right and left brackets with the speakers (as shown).  
This setup is ideal when rear surround speaker placement  
isnt possible or you want to avoid running long speaker  
cables in your listening area.  
Surround.  
Turn each surround speaker so that the arrow at  
the base is lined up with the (FRONT SURROUND)  
arrow on the front speaker. This is only necessary  
when you are using the Front Surround mode  
(MODE ON). See the operating instructions for more  
on using Front Surround.  
brackets as shown below.  
Surround  
left  
Surround  
right  
Front left  
Front right  
Center  
Subwoofer  
Listening position  
Center speaker  
Connect the speaker system.  
4
Refer to the Setting up your DVD/CD Receiver (the other part of this setup  
guide) to connect the speakers properly.  
Caution  
Please don't use the any attachments  
with the front speakers other than the  
brackets provided.  
Front Surround MODE ON  
Subwoofer  
 

Peavey Stereo Amplifier 80304543 User Manual
Peripheral Electronics Car Satellite Radio System IS77 User Manual
Pertech Printer A470e User Manual
Philips Digital Camera SPC621NC User Manual
Philips Indoor Furnishings P 8181 C User Manual
Philips Portable DVD Player DVD941 User Manual
Phoenix Gold Speaker R46CX User Manual
Precision Power MP3 Player DAC348 User Manual
ProForm Home Gym PFANBE14250 User Manual
ProForm Treadmill PFTL72582 User Manual